Reusing the saree photo
The quickest upload is the wrong one. Crop a copy to just the blouse.
The blouse is cut from exactly the photo you put in the Blouse Fabric slot. If that photo shows the saree too, the saree's border and motifs end up on the blouse.
A blouse in its own fabric, without the saree's border or pallu on it.
Here the full saree photo went into Blouse Fabric. Adjust Blouse Pattern cuts the blouse from that photo — so the finished blouse picks up the border and pallu motifs.

Crop the photo to just the blouse fabric before you upload — no border, no pallu, no floor. Now the finished blouse is cut from the blouse fabric alone.
Use Sleeveless, Quarter, Half or Full for the sleeve, and drag the fabric behind each piece to choose which part of the print it is cut from. Then Finalize.

If the blouse is the same fabric as the saree body, leave Blouse Fabric empty. Uploading the saree again as the blouse is what causes this problem.
The quickest upload is the wrong one. Crop a copy to just the blouse.
Blouse pieces are often photographed lying on the saree. Crop the saree out.
The Finished blouse preview shows the problem before you generate. Check it.
| You see | Do this |
|---|---|
| Saree border on the blouse | Replace the blouse photo with a tight crop of the blouse |
| Pallu motifs on the blouse | Same — crop out the saree |
| Blouse is the saree's fabric anyway | Remove the blouse photo and leave the slot empty |
Sometimes. In Adjust pattern, drag the fabric so the blouse piece sits on plain body fabric. A cropped photo is more reliable.
No. Only generating the shot uses credits.
Every new account gets free images after a quick phone verification.